For Christmas I got a box of balsa and I am currently in the process of building an airplane with it. I started building the airplane about a week ago and I have got quite a bit of work done on it. This is my very first balsa scratchbuilt airplane and I am learning a […]
For Christmas my siblings and I got a ping pong table. Now we don’t have it setup as a ping pong table, instead we have the playing surface resting on the kitchen table. This kind of turns our kitchen into a rec-room :P. Most people when they get a ping pong table might think “Awesome! […]
This week’s post is different than all of my other blog posts. Normally I show you something that I have made that worked like I had hoped. . . .well not this week. I planned on showing you what I had been working on at the end of last week and over the weekend but […]
This is something that I made about a year ago and I have used it just about everyday since. I go through quite a bit of exacto knife blades but throwing them away used to be a problem. I can’t throw them straight into the garbage because first of all it would/could cut the garbage […]
I recently purchased a JT Flex 8 Full Coverage paintball mask. So far I like everything about the mask . . . . except for one thing: the lack of ear protection. I don’t quite understand it really. The company took their time to create a real nice mask with a great lens, but […]
As I stated in my last blog post, my family has been talking about going canoeing again. For safety reasons I plan on keeping my iPhone with me in the boat. Although I have a Lifeproof case on my phone that keeps it waterproof, if our canoe ward to flip over, my iPhone would sink to the […]
There has been many times I have needed to cut a smooth hole in a piece of foam. When I am building RC planes I normally want to cut a smooth hole to run a pushrod or wire through the foam. When I need to do this I don’t want to just shove a […]
I have been building an RC plane recently (I will post it when it’s complete) and when I went to hook up the ailerons I realized I didn’t have Y-connector to plug the servos into one channel. It was too late in the day to go to a hobby shop and I didn’t want to […]
My RC boat is almost finished! I got the rudder installed and I just finished installing the stuffing tube, shaft, and motor. I now just have to get a battery to use and then I’ll try ‘er out! To mount the stuffing tube to the boat I drilled two holes in the center of the […]
Time to build a rudder for the boat. I made the rudder out of some brass sheet I got at the hardware store. To start I took my brass sheet and I drew on it the dimensions of the rudder. I made the rudder 1-1/4″ wide at the top and 1″ at the bottom. The […]